Halloween DIY 2: Spike Devil Horns

Here is the second easy Halloween DIY I did for Panda Head Magazine:

What you need: A headband, a Sharpie, superglue and 2 spike studs.

Step 1: Mark with a sharpie where you want your horns to go on the headband. Made sure they at equal points. Then apply superglue to where you made the Sharpie mark. Make sure you put enough glue to hold the spike, but not too much that it will run all over and make a sticky mess. Then stick the spike on the glue and hold it in place while the glue dries. (A tip is to wait 30 seconds for the glue to dry a bit before you put the spike on, so it grips on better) Wait a good few minutes while you hold the spike in place. Rather safe than sorry!

And that's it! Really quick and easy, Be careful with your horns and make sure you store them in a safe place until that Halloween party so they do not break.

Shoot photos by Caroline Lacey

Makeup: Allix Wright

Model: Ariella Steinhorn